Mastercam-X6-Mill-Level-1-Tutorial-1.pdf

(6226 KB) Pobierz
1313734679.001.png
Mill Level 1 Training Tutorial
To order more books:
Call 1-800-529-5517 or
Visit www.inhousesolutions.com or
Contact your Mastercam dealer
1313734679.002.png
Mastercam X 6 Mill Level 1 Training Tutorial
Copyright: 1998 - 2011 In-House Solutions Inc. All rights reserved
Software: Mastercam X 6
Author: Mariana Lendel
ISBN: 978-1-926955-26-1
Revision Date: November 18, 2011
Notice
In-House Solutions Inc. reserves the right to make improvements to this manual at any time and without
notice.
Disclaimer Of All Warranties And Liability
In-House Solutions Inc. makes no warranties, either express or implied, with respect to this manual or
with respect to the software described in this manual, its quality, performance, merchantability, or
fitness for any particular purpose. In-House Solutions Inc. manual is sold or licensed "as is." The entire risk
as to its quality and performance is with the buyer. Should the manual prove defective following its
purchase, the buyer (and not In-House Solutions Inc., its distributer, or its retailer) assumes the entire
cost of all necessary servicing, repair, of correction and any incidental or consequential damages. In no
event will In-House Solutions Inc. be liable for direct, indirect, or consequential damages resulting from
any defect in the manual, even if In-House Solutions Inc. has been advised of the possibility of such
damages. Some jurisdictions do not allow the exclusion or limitation of implied warranties or liability for
incidental or consequential damages, so the above limitation or exclusion may not apply to you.
Copyrights
This manual is protected under International copyright laws. All rights are reserved. This document may
not, in whole or part, be copied, photographed, reproduced, translated or reduced to any electronic
medium or machine readable form without prior consent, in writing, from In-House Solutions Inc.
Trademarks
Mastercam is a registered trademark of CNC Software, Inc.
Microsoft, the Microsoft logo, MS, and MS-DOS are registered trademarks of Microsoft Corporation; N-
See is a registered trademark of Microcompatibles, Inc.; Windows, Windows XP, Windows Vista,
Windows NT and Windows 7 are registered trademarks of Microsoft Corporation.
Zgłoś jeśli naruszono regulamin